Troubleshooting - Rival 11560 Manual Del Usuario

840193801 ENv05.qxd:840135000 Ev00.qxd
7
Wrap cord around the cord wrap on
bottom of steamer.
PROBLEM
Unit won't steam.
Not enough steam.
Flexible steam hose
drips and/or leaks.
Steamer leaves water
spots on clothing.
Flexible steam hose
emits a gurgling
noise.
11/19/10
CARE AND CLEANING

TROUBLESHOOTING

PROBABLE CAUSE
• Make sure there is water in the water tank and
unit is plugged in and switched to ON (I)
position.
• Water deposits have built up in unit. See "Care
and Cleaning" section.
• Do not hold the steam handle/nozzle too low for
more than 20 seconds, or steam will condense
into water inside the hose and may block nor-
mal steam flow. Periodically lift steam nozzle/
handle as high as possible to let any condensa-
tion in flexible steam hose drain back into unit.
• Do not allow loops in the flexible steam hose
for more than 20 seconds.
• Allow enough time (approximately 2 minutes)
for steamer to preheat before use.
• Periodically lift steam nozzle/handle as high as
possible to let any condensation in flexible
steam hose drain back into unit.
• Normal during use. To maintain steam flow,
fully extend flexible steam hose to allow steam
to flow freely.
9:26 AM Page 9
(CONT.)
8
Wrap flexible steam hose around top
of steamer base and slide nozzle
down onto storage hook.
9