18. Children should be supervised to ensure that they do not play with this appliance.
19. Keep your unit out of reach of children as it is not intended for use by children.
20. This appliance is not to be used on, by or near children or invalids.
21. To prevent accidents and injury to you or damage to the unit -when your Callous Remover
is in use, keep it away from the hair on your scalp, your eyebrows, eyelashes as well as clothes,
brushes wires, cords, shoelaces, etc.
22. Do not continually rub the unit on the same area or apply strong pressure.
23. Keep the protective cover on your unit when it is not in use.
24. Do not disassemble this device.
Before using your Callous Remover, please read this instruction manual carefully and completely.
Battery Installation
1. Remove the battery cover (Battery cover lock piece) by turning it 90 degrees to the left until
it clicks into place (fig. 1) and then pull it down (fig. 2).
2. Insert 2xAA alkaline batteries in the battery compartment following the battery direction sign
(fig. 3) as imprinted on the back of the unit.
3. Close the battery cover by turning it 90 degrees to the right (fig. 4) until the cover clicks into
place and locks (fig.5).
How to use
This Callous Remover is designed for smoothing coarse skin on the feet and wheels, Do not
use this device anywhere else on the body.
1. Wash and clean the skin and dry fully.
Note: Do not use on broken or bleeding skin.
2. Make sure the Rollers Grinding Head is placed into the unit. See section of Changing the
Rollers Grinding Head on how to remove and replace head.
3. Remove the protective cover from the unit and it is ready to Use.
4. Turn on the unit by pressing the safety switch Sock, in the center of the On/Off switch, and
at the same time push the switch up (fig. 6).
5. Gently rotate (back and forth or side to side)(fig.7) the callous/corn/hard skin area for 2-3
seconds. Dot not press hard-gently glide the unit over desire area. The unit will stop if it is press
too hard on the skin. Stop and check if you have achieved the softness you desire.If not, go over
the area for 2-3 more seconds and check again. Continue to use this method until the level of
smoothness is obtained.
Warning: Stop using if skin becomes sore or Inflamed.
Warning: Do not use on skin for more than 2-3 seconds at a time.
5. Turn the unit off (fig 8).
6. Rinse the skin or use a wet towel to get rid of the excess dead particles.
7. To clean this Callous Remover, please see the Cleaning section.
8. Keep the protective cover on your unit when it is not in use.
Changing the Rollers Grinding Head
Change the Rollers Grinding Head as needed for best result the Rollers Grinding Head last for
a few sessions depending on frequency of use and size of area being treated Replace as needed.
Make sure the unit is turned off before replacing the Rollers Grinding Head.
1. One hand hold the head,another hand press in the release button, on the side of the unit, the
- 8 -