Publicidad
Idiomas disponibles
Idiomas disponibles
SMART-PAK COMBO BOARD HANGING INSTRUCTIONS
(16') 2-PIECE STYLE "A"
Because of the wide variation of mounting surface construction, specific mounting hardware is not included. For the most secure mounting, the
accessory tray, map/hanger rails, and the "L" hangers should be attached directly into wall studs. Ghent recommends using #8 x 1 1/4" pan head type
self-tapping screws (not included). When wall studs can not be used, we recommend using wall anchors (not included).
It is also recommended that at least two people perform the installation of the board.
STEP 1: Press the accessory tray end caps over the ends of accessory tray. See Illustration 1.
STEP 2: Determine the desired height from the floor to the bottom of the board. Scribe a level line on the wall at that distance. Position the bottom edge
of the accessory tray along this line. Using the groove at the rear of the accessory tray as a guide, drill 1/8" diameter holes through the accessory tray
and into the wall studs. Fasten the accessory tray to the wall with screws. Position the bottom edge of a lower "L" hangers along the same line,
approximately 48" from the end of the accessory tray. Securely fasten the lower "L" hanger to the wall with screws. See Illustration 2.
STEP 3: Lift a marker board half onto the mounted accessory tray. Align the unframed end of the board with the center of the accessory tray. Using the
lower "L' hangers as a template, mark the hole locations for the bottom mounting screws. Remove the board, drill 1/8" diameter holes at each of the
marked locations and reattach the board with the screws provided. See Illustration 2.
STEP 4: Place a map/hanger rail over the top of the marker board half and center it on the marker board. Using the groove at the rear of the map/hanger
rail as a guide, drill 1/8" diameter holes through the map/hanger rail and into the wall studs. Fasten the map/hanger rail to the wall with screws. See
Illustration 2. Lift and center the header tack board half onto the map/hanger rail.
STEP 5: Scribe a line on the wall along the top edge of the header tack board half. Remove the tack board and position the top edge of the "L" hangers
along this line at the wall stud locations. Locate each screw in the center of each hanger's slot. Snugly fasten each hanger with screws to the wall. See
Illustration 3.
STEP 6: Tap the "L" hangers up until the screw is resting in the lower end of the hanger slot. Replace the header tack board half onto the map/hanger rail
and tap the "L' hangers down against the top frame. Using the "L' hangers as a template, mark the hole locations for the top mounting screws. Remove
the tack board, drill 1/8" diameter holes at each of the marked locations and reattach the tack board with the screws provided. See Illustration 3.
STEP 7: Install the marker board divider and the tack board divider rails over the unframed end of the board halves you just mounted. See Illustrations 2
and 3.
STEP 8: Repeat steps 3, 4, 5, and 6, for the other side of the board.
STEP 9: Place the map rail end caps over the ends of the map/hanger rail. Using the end cap as a template, drill 1/8" holes through the map/hanger rail.
Secure with the screws provided to complete the installation.. See Illustration 4.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
1
IS-SPC-16 6/11
Publicidad
