Identificación De Los Componentes; Control Panel; Rear Panel; Connection Instructions - Sonia Maia Gal H2401 Manual De Instrucciones

IDENTIFICACIÓN DE LOS
COMPONENTES
1 2
4 5
1
Handpiece with double stick probe
2
Double stick probe cable connector
3
Double stick probe flexible cable
4
Handpiece with roller probe
5
Roller probe handpiece cable connector
6
Roller probe flexible cable
- Double stick probe: to treat small or irregular areas
of the skin
- Roller probe: to treat large and regular areas of
the skin

CONTROL PANEL

19 18 17
1 2 3 4 5 6
1 Very sensitive skin indicator.
2 Sensitive skin indicator
3 Normal skin indicator
4 Skin type selection
5
Power on indicator
6
On / off button
7
Run indicator
8
Start / Stop button
9
Pause indicator
3
6
16 15 14 13
7 8 9 10 11 12
10 Ion conduction selection button
11
Cation conduction indicator (positive charge)
12
Anion conduction indicator (negative charge)
13
Power display
14
Decrease power button
15
Increase power button
16
Galvanic current conduction indicator
17
Increase time button
18
. Decrease time button
19
Timer

REAR PANEL

1
1 Probe handpiece cable connection
2
Power supply switch
3
Electrical power supply connector
4
Fuse

CONNECTION INSTRUCTIONS

● Connect the power cable to the rear panel of the
main body.
● Connect the cable of the handpiece to the
corresponding output on the rear panel.
● It is only possible to connect one of the two
handpieces at the same time, so you must select
the one you need according to the treatment to be
performed.
POWER AND CONFIGURATION
● Turn on the power switch on the rear of the
machine and press
The power indicator
will be in standby mode and ready for operation. On
the control panel:
- The timer will show 15 minutes.
2 4 3
on the control panel.
will light up. The machine
EN
3