Connections & Settings; Install Tf Card (Only Applies To Ultrascan Obdcan Elite); Connections - TOPDON Ultrascan OBDCAN Serie Manual De Usuario

4 Connections & Settings
4.1 Install TF card
Elite)
1) Take out the TF card from package box.
2) Insert the TF card into the TF card slot perpendicularly. Make
sure is fully inserted in the right place with the "micro" label facing
upward.
Note: You can hear a clicking sound if you insert the TF card in the right
place. Press the card slightly, it will be ejected automatically.

4.2 Connections

1) Turn the ignition off.
2) Locate the vehicle's DLC socket.
3) Plug one end of the diagnostic cable into the OBDII 16pin
connector of Ultrascan OBDCAN Serial products, and connect
the other end to the vehicle's DLC.
4) Turn the ignition on. Engine can be off or running.
5) After finishing, the system will start initializing. After initialization,
the system will enter the main menu interface. See Fig. 4-1.
Figure 4-1 (For Ultrascan
OBDCAN PLUS)
CAUTION: Don't connect or disconnect any test equipment with ignition
on or engine running.
Ultrascan OBDCAN Series User's Manual
(Only applies to Ultrascan OBDCAN
Figure 4-1 (For Ultrascan
OBDCAN Elite)
EN
7