Rear Panel - Vibbel Khona Press 0009351 Manual De Instrucciones

REAR PANEL

1
Air pressure tube connector
2
Electrical power supply connector
3 Fuse
CONNECTION AND ASSEMBLY
INSTRUCTIONS
● Connect the power cable to the rear panel of the
main body.
● Connect the piece coming from the mat (the one
with a mobile revolving cap on one end) to the air
pressure tube connector located on the rear panel
of the main body. Insert the piece and then twist
the cap until it feels tight enough.
● Connect the pressure tubes housed within the mat
to the various sections of the suit. A number will
indicate where each tube should be connected.
9
8
5
4
3
2
1
0
EN
4
1 2 3
9
7
8
6
5
4
3
2
1
0
POWER AND CONFIGURATION
● Press the on/off button to start the device. When
it is on, a beep will sound and the welcome screen
will be displayed.
- Press the screen to move to the next display
screen and the parameter control.
● The preset values when switching on the device are
as follows:
- Length of treatment: 30 minutes
- Operating mode: A
- Pressure level: minimum
- All sections inflated
- Inflation time for each section: 10 seconds
● Set the previous parameters
- Length of treatment: maximum 60 minutes
- Operating mode: A, B, C, D
- Pressure level: minimum (0.25 bar), medium (0.30
bar), maximum (0.35 bar)
- Inflation time for each section: from 1 to 15
seconds
- One or several sections of the suit can be
disabled.
● There are 4 preset operating modes:
- Mode A: Foot to arm sequence, with each section
inflating independently and followed by the
simultaneous inflation of all the sections.
Arms
9
8
Waist
7
6
Legs
5
4
3
2
Boots
1
0
- Mode B: Foot to arm sequence, with sections
inflated in pairs and followed by the consecutive
inflation of all the sections.
Arms
9
8
Waist
7
6
Legs
5
4
3
2
Boots
1
0