Mark BIG FLASH II 1500 Manual De Uso

• Mounting Bracket
• Lamp Replacment Cover
Please read these instructions carefully befor use
Introduction
Congratulations on the purchase of your new strob lighting effect. you will enjoy your strob light freely.
To assist with the care and use of the product we have prepared this short guide.
Troubleshooting
• If the unit is not functional – check main power supply is 'on' and check fuses.
• If the unit is functional but lamp does not light - lamp may require replacing.
• If after trying this solution you still have a problem contact your dealer.
Caution
Do not obstruct the air vents.
Do not touch unit or lamps while hot.
Never put any objects through the air grill on the top of the unit.
No user serviceable parts inside, please refer to your dealer for service.
Power Connections
The unit is supplied with a power plug appropriate to its voltage and destination. Should any other
connections be required they must be carried out with the following configuration.
Earth = Green/Y ellow cable
Neutral = Blue cable
Live = Brown cable
In the USA & Europe, it is required that all plugs are 3-pin type i.e. with Earth/Ground connection. This
device have a circuit breaker that has protective functions as shortage and overloading.
Operation
This lighting ef fect has been designed to function on a mains power supply of either 120V~60Hz or
230V~50Hz and has been fitted with a suitable power plug for use with your local voltage. Check the label
on the unit and the power plug for the correct voltage.
BIG FLASH II 1500
BIG FLASH II 1500
User Manual
Fig. 1
User Manual/Manual de Uso
At the Rear:
• Rotary Speed Control
• 1/4" x 2 Mono Jacks
for Linking
• Circuit Breaker
• Dimming knob
Pag 1