Publicidad
Idiomas disponibles
Idiomas disponibles
5. Assembly
1.
Take the fan out of the package and check the appliance as well as the scope
of delivery mentioned in the table above. Please contact the supplier if any
part is missing or has been damaged. Place the rear protective cage (5) on
the rotor axis (6). Make sure that the handle is facing up.
2.
Tighten the protective cage firmly using the mounting nut (4).
3.
Then insert the rotor blade (3) onto the rotor axis (6) and fasten it using the
appropriate mounting nut (2).
4.
Caution: The mounting nut needs to be tightened counter-clockwise.
5.
Mount the front protective cage (1) onto the rear protective cage. A hole is
provided for a locking screw (13) at the bottom of the two protective cages.
6.
Insert the locking screw (13) through the hole of the front and rear guards
and fasten it using the locking nut. Then connect the four mounting brackets
to the side.
7.
Take the pedestal (13) and connect the outer pipe (10) to the pedestal.
8.
Fix the outer pipe (10) to the pedestal (11) from below using the mounting
screw with washer (12).
9.
Pull the inner pipe (8) from the pedestal outer pipe (10), and fix it by tight-
ening the height adjustment screw (9)
10.
The fan and pedestal have to be finally assembled.
11.
Attach the fan to the pedestal by placing the motor unit (6) on the inner
pipe (8) and secure the fan using the locking screw (7).
22
English
Publicidad
