Publicidad
Idiomas disponibles
Idiomas disponibles
In any of the following situations, the smart clamp turns protection on.
LED Indicator
The red/green led will flash
The green light is always on
The red light is always on
The red light flashes slowly
The red LED flashes quickly
The green light flashes slowly
Situations
Ready to work
Work status
1.battery clamp is reversely connected
-- check whether the clip is reversely connected
2.the clamp is short- circuited
-- check whether two clamps together connect or connect both cable
clamps to the same piece of metal
Back charge protection, the voltage of the car battery is higher than 12.6v
-- No jump starter needed, the car battery is enough to start your car
The temperature of the clamp exceeds 65(+/ -5)degrees
-- remove the clamp untill the red green led flash
The voltage of the starter is too low
-- try to replace the startup power supply or charge it in time
EN
08
Publicidad
