How To Replace The Fuse - GEARSTONE CS-WP7 Manual Del Usuario

How to replace the fuse

1
◆As shown in step ① in the left figure above: unplug the power plug from the power
socket;
◆As shown in step ② in the left figure above: Use a small, small-head screw for
household use to lift the fuse out of the power socket;
◆As shown in step ③ in the above right figure: Take out the fuse fuse tube according
to the direction of the figure, and insert it after replacement.
Note: The specification of the fuse fuse of this machine is 250V/10A, Φ5*20mm
Adjusting the degree of folding handle
How to Replace the Fuse 07
2
Slotted screwdriver
insertion position
When this machine is shipped, the part has
been adjusted to a slightly suitable tension.
However, due to the size of the wrist, the user
can appropriately adjust the folding handle
according to their preferences. Do not adjust
it too loosely. Too loose will result in shaking
due to the excessive gap between the folding
part of the tube and the main unit. As shown
3
in step ① in the above figure, pull out the
silicone round plug at the lower end of the
1
2
left tube; combine the equipped inner six
wrench and sleeve wrench into a saving lever,
as shown in step ② in the above figure, The
end of the hex head of the barrel wrench is
inserted into the lower end hole of the left
tube and fits with the hex screw. Rotate
clockwise to clamp, otherwise it is slightly
loose.
3