Cleaning And Maintenance - Klarstein PRO 10033348 Manual Del Usuario

EN
20
Defrost device manually
Despite automatic defrosting, a layer of ice may form in the appliance after a certain
period of time. If the layer is thicker than 1 cm, you must defrost the appliance manually.
Take everything out of the fridge, set the regulator to OFF and leave the fridge door
open. Once the ice has melted, dry the interior with a soft cloth and turn the thermostat
back on.
Note: When the appliance is switched on again, it may take up to 12 hours to restore
the desired temperature inside the appliance.

CLEANING AND MAINTENANCE

• Disconnect the plug from the socket and remove everything from the refrigerator.
• Wipe the interior with water and a mild detergent. Make sure that the control panel
and the plug do not get wet. Do not use abrasive cleaners for cleaning.
• Never remove ice with pointed tools or metal tools.
• Dry the unit thoroughly before putting it back into operation.
• To ensure trouble-free operation, the condenser should be cleaned with a
vacuum cleaner every three months. The condenser at the rear under the grille. In
particularly dusty places, the condenser must be cleaned more often.
• Clean the seals with mild soapy water.
Replacing Lamps
• Disconnect the plug from the outlet.
• Remove the screws from the lamp cover and remove the old lamp.
• Insert the new lamp and attach the cover.