Putting Into Operation - IARP CF-PLANET Instrucciones De Empleo Y Manutención

INSTALLATION
Take out packing and clean all the cabinet using warm
water together with 5% of neutral soap then dry it
with a soft-cloth;
Warning! The refrigerator must be installed on a
perfectly even surface, far away from any heat source
included sun rays. It is necessary to allow a good circu-
lation of air in the condenser group, avoid obstructing
the front grid by placing any boxes in front of it.
Do not install the unit in open places and don't expose
it to rain.
10 cm
Keep a distance from the walls.

PUTTING INTO OPERATION

Check that the voltage on the identification plate is the
same as that of the network. THE ELECTRICAL
SUPPLY LINE TO WHICH THE REFRIGE-
RATOR WILL HAVE TO BE CONNECTED IS
TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA);
IT IS ALSO TO BE LINKED TO THE GENERAL
EARTHING PLANT.
Earthing is necessary and compulsory by law. Absolu-
tely never use reduction units, patch cords, adapters
or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The manufacturer disclaims all responsability for any
damage to people or things due to incorrect observance
of this rule.
INFORMATIONS ABOUT USE
THE REFRIGERATOR IS NOT SUITABLE FOR
WORKING IN DANGEROUS ENVIRONMENT
WITH RISK OF FIRE, EXPLOSIONS OR RADIA-
TIONS.
Never use electrical equipment in the refrigerated
compartment.
Never place containers of liquid on or immediately
20 cm
above the ticket counter; should the content spill out,
it would damage the counter.
Install and position the unit in such a way so as to allow
easy access to the power socket.
Operation is regular with ambient temperature indicated
on technical data plate.
-6-
ENGLISH