James STANDARD Libro De Instrucciones página 13

setting (0' - 15').
When the extractor connects to the mains, the presence sensor is precharged for one
minute. The extractor then remains on stand-by ready for normal operation.
The extractor starts up when the Presence Detector is activated. If the sensor does
not detect any movement, the extractor will remain in operation for the length of time
selected in the Timer setting and will eventually stop, returning to stand-by.
LIGHT (see figure 4C)
Fan equipped with Timer and Ambient Light. Timer adjustable between 0' and 15'. Ad-
justment of light intensity between off and maximum intensity.
To regulate the timer, rotate the "TIMER" control knob clockwise to increase the time
setting (0' - 15').
To adjust the brightness of the LED lights, rotate the LIGHT knob in a clockwise direc-
tion to increase the light intensity (0 – MAX).
The extractor is activated with the switch, and the LED lights come on at MAXIMUM
intensity. When the switch is turned off, the fan continues to operate for the set time
and the LED lights are replaced by the selected form of lighting. Finally the fan switches
off fully and the level of lighting remains at the set intensity.
To finish the installation, verify that all the connections have been done co-
rrectly and make sure that the cables are placed correctly.
Install the front cover in its position and make sure that it cannot be removed without
using a tool (see fig. 7).
Make sure that the blades turn freely.
Cleaning and Maintenance:
• Before cleaning make sure that the appliance is not connected to the electric net-
work and prevent it from being reconnected by accident.
• Clean with a damp cloth regularly.
• The appliance does not require additional maintenance.
Always demand original spare parts for repairs.
• The motor, propeller and all components should be inspected periodically to ensure
that they are not dirty and have not suffered any damage. The frequency of inspections
depends on the appliance's operating conditions.
• Remove the dirt on the propeller and the inner parts of the casing to avoid imbalances
during operation, a decrease in aerodynamic performance and motor damage.
This device is not a precision thermometer / hygrometer.
The displayed values of Tª and HR are only for reference
THE MANUFACTURER reserves the right to make any technological improvement or
modification without prior notification.
The symbol on the product or on its packaging indicates that this product may
not be treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help prevent potential negative conse-
quences for the environment and human health, which could otherwise be caused
by inappropriate waste handling of this product. For more detailed information about
recycling of this product, please contact your local city office, your household waste
disposal service or the shop where you purchased the product.