Features; Operation; Loading Cleat Nails; Unloading Cleat Nails - Husky HD18GLCN Guía De Uso Y Cuidado

Features

Ergonomically designed handle
For ease of operation and reduced fatigue.
Non-marring design
Provides increased protection from marring when
working with a finished flooring surface.
Anodized aluminum magazine
For long lasting durability.
Durable construction
Lightweight, high-strength aluminum body with heat
treated steel parts.
Fiberglass mallet with rubber head included

Operation

1

Loading cleat nails

WARNING: The tool may fire when it is first connected
to the air resource. Always connect the tool to the air
source before loading fasteners to prevent injury from
unintended cycling.
Connect the tool to the air source.
Insert a strip of fasteners from the rear of the magazine
(A). Be sure the fasteners are pointed downward. (See
figure 1 & figure 2.)
This tool uses a spring loaded bypass lever in order to
load and upload the nails. Once the nails are properly
inserted, pull the pusher (B) completely back, pressing
against the bypass lever (C) of the pusher. (See figure 3.)
Once the pusher hits the back of magazine, allow the
pusher to slide forward and engage the nails, pushing
them to the nose of the tool. (See figure 4.)
Figure 1
Rear of magazine (A)
Insert nail strip
Operation (Continued)
Figure 2
Bypass lever (C)
Pusher (B)
Figure 3
Slide Back
Figure 4
Engage nails
WARNING: The tool may fire when it is first connected
to the air source. Always connect the tool to the air
source before loading fasteners to prevent injury from
unintended cycling. Always make sure the tool's
magazine is empty at the beginning of each work
session, before connecting to an air source.
WARNING: Use only those fasteners recommended
for use with this tool. Fasteners not identified for use
with this tool by the tool manufacturer are able to
result in a risk of injury to persons or tool damage
when used in this tool.
2

Unloading cleat nails

Disconnect the tool from the air source.
Pull back the pusher, pressing bypass lever of the pusher,
allow the pusher to bypass nails and slowly returning to
the nose of the tool.
Slide the fastener to the rear magazine.
Press bypass lever
3
Changing the foot plate
The tool is equipped with a factory pre-installed 9/16 in. to
5/8 in. foot plate (D), and an additional uninstalled 3/4 in. foot
plate, 3/8 in. to 1/2 in. foot plate and 7/16 in. flooring shim.
To change the plate: