Publicidad
Dear Customer,
Congratulations on purchasing this product. Please read and follow these instructions, in order to avoid damaging
the item. We do not cover any damages that may arise from improper use of the item or the disregard of the safety
instructions.
In the box:
1 x
A
1 x
B
2 x
C
4 x
D
4 x
Mark the spots for drilling holes on the wall you want to hang the awning. Use the brackets (C) as
templates.
The lower bracket should be attached in a height of 20-30 cm from the ground. The second bracket
Step 1
should have a height of 120 cm (for 10028008/13/14), 140 cm (for 10028015/16/17) or 160 cm (for
10028018/19).
Drill 12x55 mm holes. Ensure before there are no gas, water and electrical lines that run in the wall.
Step 2
Attach the brackets (C) to the wall, using the supplied screws and dowels (or, alternatively, use any
other screws and dowels that might be more appropriate for the particular wall material, as long
Step 3
as they fit).
Hang the awning into the brackets.
Step 4
Put the pile (B) to the spot you want it to stand, max. 3m away from the wall attachment. Use the
Step 5
base plate of the pile as a template for marking the drilling spots on the ground.
Drill 12x55 mm holes with a drill that is appropriate for the particular flooring.
Step 6
The supplied metal frame fixings are appropriate for flooring of concrete, solid or perforated brick
Step 7
with wood panelling or similar.
Pull out the awning and
Step 8
attach it to the pile, pushing the hook down as shown in the illustration.
Step 9
Assembly
6
Publicidad
