GE 29884-PK1 Manual De Usuario página 11

e) Install the Rubber End Caps after all the Reflector Rods are
assembled into the Reflector Brackets.
f) Connect the two assembled halves of the Reflector Brackets
together by aligning the connecting tabs and sliding the halves
together until the halves are evenly aligned (Fig. 3c).
4) Assembling the Assembled Antenna Main Boom to the Assembled
Reflector
a) Slide the metal end of the antenna Main Boom through the center
of the Reflector from the concaved side of the Reflector until the
bolt holes align with the bolt holes on the Reflector Brackets.
b) Slide the two M6 X 12mm Flat Washers onto the two M6 X 10mm
Bolts.
c) Screw in the bolts through the Reflector Bracket top and bottom
into the antenna Main Boom until bolts are tight. The finished
assembly should look like the illustration in (Fig. 4a).
d) Remove the Wing Nuts from the "U" Bolt.
e) Insert the "U" Bolt through the metal portion of the antenna Main
Boom from the jagged notched side of the antenna Main Boom
(Fig. 4b).
f) Thread the Wing Nuts partially back onto the "U" Bolt; do not
thread Wing Nuts all the way down at this time.
Fig. 3c
Fig. 4a
Fig. 4b
11