Logic3 WIP025 i-Station25 Manual Del Usuario página 4

i-station25 (WIP025) - user Manual
Thank you for purchasing the Logic3 i-Station25. As with all Logic3 products it has been built to the highest manufacturing
standards and tested throughout its development, to ensure you get the best possible product. Please read through and
familiarize yourself with this manual before you use the i-Station25.
set up of i-station
1. Remove the battery compartment cover by sliding it upwards.
2. Choose your source of power :-
Mains Power (see fig.1A)
Battery Power (see fig.1B)
WARNING: Please ensure that the batteries are inserted correctly. If the batteries are inserted incorrectly
(reversed polarity), this may cause personal injury as well as damage to your i-Station
3. Bring the 30pin connector forward and the connector will lock into place (a click sound can be heard) - (see fig.2)
4. Slide your iPhone/iPod onto the 30 pin connector and push the iPhone/iPod back until the back of the iPhone/iPod
rests on the i-Station25 - (see fig.3)
5. Insert the battery into the remote control
notE:
1. After the iPhone has been docked to the speaker, the iPhone may stop responding for up to 5seconds, whilst it com-
municates with the speaker.
2. Do not remove the iPod/iPhone from the speaker immediately after docking. It is recommended that the iPod/iPhone
should be removed if required after 10seconds after being docked.
3. If a warning message is displayed on the iPhone after it has been docked, remove the iPhone and dock again.
using the i-station
1. Power is turned ON/OFF via the Power Button located on top of the i-Station25 (Stereo symbol will illuminate Blue
when switched ON).
2. The speaker system is preset to a 30% volume level; the volume level will be displayed on your iPhone/iPod screen.
This can be adjusted by using the Up and Down keys located on top of the i-Station or via the remote control, the
volume bar on the iPod/iPhone will also move according to the volume adjustment.
3. The i-Station25 has a built in Accelerometer which allows the i-Station25 to be tilted on its side while keeping its stereo
speaker positioning. The stereo speaker position will automatically adjust according to the orientation of the i –Sta-
tion25 (see fig.4)
4. iPod/iPhone navigation mode (for all iPods/iPhone in vertical position; these functions do not work for iPod touch and
iPhone in Horizontal position):
• Menu button: Bring back to the upper level of menu
• Select button: Enters into next level of menu
• UP / DOWN button: Menu cursor moving up and down
• Play / Pause button: Play or Pause the music from iPod
• Next / Previous button: Jump to Next or Previous Track
5. To remove the iPhone/iPod pull the iPhone/iPod towards you until it comes out of the docking area (Do not pull it out
too far as this may cause damage to your iPhone/iPod or i-Station).
Slide the iPhone/iPod out of the 30 pin connector.
The i-Station25 is fitted with a power saving mode, if the unit is left on for a certain amount of time without playing any
music, it will switch into the power saving modes.
- Plug in the DC jack to the rear of the i-Station25 (DC 5V)
- Select and fit the correct plug adapter to suit your power supply
- Plug the power supply into your mains socket and turn the mains socket ON
- Replace the battery compartment cover (Ensure the wire goes through the slot on the
battery compartment cover)
- Insert 4 x AA batteries observing the Polarity Markings
- Replace the battery compartment cover
4