Installation Instructions - Rotary RJ7100Y Manual De Instrucciones

INSTALLATION INSTRUCTIONS

1. Place jack on runway tracks at front and rear with
air pump, facing ends of runways. Adjust width of
rolling jack to fit runway track. Make sure wheels
are on the tracks. Center rolling jack between
runways.
2. Install male quick-disconnect coupling in air pump
to match shop fittings if required. Install filter/
Fig. 1
RUNWAY
RUNWAY
RUNWAY
RUNWAY
RUNWAY
RUNWAY
RUNWAY
RUNWAY
regulator/lubricator, set to 100-120 psi and one drop
of oil per minute. Capacity/serial no./model no. of
rolling jack is stated on the nameplate.
Note: The bridge will consume 20cfm of air.
DO NOT OVERLOAD JACK.
RJ7100Y
RJ7100Y-X
RJ6100Y
RJ6100Y-1
3
MALE COUPLING
MALE COUPLING
AIR PUMP
AIR PUMP
RUNWAY
RUNWAY
MALE COUPLING
MALE COUPLING
AIR PUMP
AIR PUMP
RUNWAY
RUNWAY
MALE COUPLING
MALE COUPLING
AIR PUMP
AIR PUMP
RUNWAY
RUNWAY
MALE COUPLING
MALE COUPLING
AIR PUMP
AIR PUMP
RUNWAY
RUNWAY