RCBS ULTRASONIC CASE CLEANER 2 Instrucciones De Producto página 10

off heater after it has been in operation for 90 minutes, regardless if the water temperature has reached the pre-set
temperature. If using cold tap water and trying to heat up to 60°C/140°F, the overheat safety will automatically
shut the heater off before desired temperature is reached. If this happens simply depress the heater button again
to turn heater on. Using warmer water will aid in reducing the amount of time needed to bring water to desired
temperature.
OPERATING INSTRUCTIONS
CAUTION Leave the Ultrasonic unit unplugged until you have read all the instructions and are ready
to clean cases.
1. Ensure Drain Valve is in closed position by rotating valve in counter-clockwise direction as shown in Photo
2.
2. Place items in basket to level shown in Photo 3. Note: do not place items higher than the top of the basket
to ensure water completely covers items in basket and is not above Max fluid fill line shown in Photo 4.
3. Pour water or cleaning solution into reservoir and ensure fluid level is not above level shown in Photo 4.
Note: With basket filled and placed in reservoir containing fluid, ensure fluid level does not exceed level shown
in Photo 5.
CAUTION If the unit is turned on without water, and left on for over 45 seconds, it may severely reduce
the life or damage the unit.
Drain Valve
Closed Position
Photo 2
No Items Above Top of Basket
Photo 3
Fluid Not To Exceed MAX Fill Line
Photo 4
WARNING Care should be
used when operating electrical
appliances in wet areas or
around water. Always unplug
unit when filling or draining
tank. Operating unit on a GFCI
outlet is highly recommended.
Photo 5
Max. Fluid Level Not To Exceed This Mark
On/Off Switch Power Cord
Photo 6
7