Kohler K-99695 Manual De Instrucciones página 7

Install the Controller (cont.)
NOTE: The power supply should be placed on a horizontal surface.
Do not secure the power supply to any surface.
Install a horizontal board to accommodate the power supply.
Ensure the cord can be routed to the electrical outlet without
being pinched.
Using a hole saw, drill 1" (25 mm) holes through the studs at the
top and bottom of the wall cavity to allow proper air flow.
Hook the controller onto the protruding screws.
Route the power supply from the controller to the electrical
outlet.
Kohler Co. 7 1218131-2-A