Axis T8123-E Manual Del Usuario página 3

Safeguards
• Store the Axis product in a dry and ventilated environment.
• Avoid exposing the Axis product to vibration, shocks or heavy pressure. Do not install the product on
unstable brackets, unstable or vibrating surfaces or walls, since this could cause damage to the
product.
• Only use applicable tools when installing the Axis product; excessive force could cause damage to the
product.
• Do not use chemicals, caustic agents, or aerosol cleaners. Use a damp cloth for cleaning.
• Use only accessories that comply with technical specification of the product. These can be provided by
Axis or a third party.
• Installation and removal of the PoE Midspan must be carried out by qualified personnel only.
• Read the installation instructions before connecting the PoE Midspan to its power source.
• Follow basic electricity safety measures whenever connecting the PoE Midspan to its power source.
• A voltage mismatch can cause equipment damage and may pose a fire hazard. If the voltage indicated
on the label is different from the power outlet voltage, do not connect the PoE Midspan to this
power outlet.
• The equipment is intended only for installation in a Restricted Access Location.
• All wiring and connections shall be in accordance with NFPA 70 (NEC). Applicable to US only
• This product is fitted with a NEMA 5-15P plug for connection to the branch circuit. If other
attachment methods are required, please reference local codes and requirements for proper connection
to the branch circuit.
• This product is not intended to become a permanent part of the building structure.
• Power supply cord must not be attached to the building surface nor run through walls, ceilings, floors
and similar openings in the building structure.
• Measures must be taken to prevent physical damage to the power supply cord, including
proper routing.
• The PoE Midspan "DATA IN" and "DATA PWR OUT" ports are shielded RJ-45 data sockets. They cannot
be used as Plain Old Telephone Service (POTS) sockets. Only RJ-45 data connectors can be connected to
these sockets.
• Ensure cable length from Ethernet network source does not exceed 100 m (333 ft). The PoE is not a
repeater and does not amplify the Ethernet data signal.
• Use a splitter if desired, ensure that the splitter is connected close to the terminal and not on the Mid-
span.
• The PoE Midspan AC power plug shall be connected to a sealed box in order to meet EN60529 level
IP66 and NEMA 250 level 4x.
• The PoE Midspan AC power lines shall be connected to the socket-outlet, which shall be installed near
the equipment and easily accessible.
• Designed to meet GR-1089-CORE lightning protection demands.
• This Axis product shall be used in compliance with local laws and regulations.
• Do not attempt to repair the product by yourself, contact Axis or your Axis reseller for service matters
• Installation and removal of the T8123-E/T8124-E must be carried out by qualified personnel only.