Ce Declaration Of Conformity - Fermax BASIC-2B Manual Del Usuario

Ocultar thumbs

Contenido

página de 25

/ 25
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Cod. 97853

V06_17

Single reset

In programming mode, held down and the reset "MR" and by pressed the transmitter you want to

delete, and you will hear a confirmation tone. After 10 seconds without programming or quickly

pressing the programming button, the receiver will exit programming mode, issuing two acoustic

signals of 1 sec.

GROUPS

Receivers can be configured with a group (from 0 to 7) so that there is no interference when

working near each other.

GROUP CONFIGURATION

The configuration can be carried out with the programming tool or by self-programming as

follows.

Self-programming After the receiver has been totally reset, it will be configured with the group of

the first radio-programmed transmitter by enabling the hands free mode.

Exception: If the receiver has been configured using programming tools, the group may only be

changed with the programming tool.

Operations On powering the receiver, the led R1 will flash the same number of times as the group

number with which it is configured.

WARNINGS

Disconnect the power supply before handing the unit.

In compliance with the European Directive low-voltage electrical equipment, we hereby inform

users of the following requirements:

· For units which are permanently connected, an easily accessible circuit-breaker device must be

built into the wiring system.

· This unit must always be installed in a vertical position and firmly fixed to the structure of the

building.

· This unit must only be handled by a specialised installer, by his maintenance staff or by a duly

trained operator.

· The instruction manual for this unit must always remain in the possession of the user.

· Terminals of maximum section 3,8mm2 must be used for the power supply connections.

· Use time delayed fuses.