Technical Characteristics; Installation And Connections - Fermax BASIC-2B Manual Del Usuario

Cod. 97853 V06_17
User's Manual

TECHNICAL CHARACTERISTICS

Frequency
Coding
Memory
Number of relays
Supply
Relay contacts
Standby/Op. consumption
Op. temperature
Watertightness
Size
Box dimensions

INSTALLATION AND CONNECTIONS

Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the
cables through the bottom of the receiver. Connect the power cables to the terminals marked in
the mother board, as indicated. Fix the receiver front to the rear part using the screws supplied.
OPERATING
The pilot lights are activated every 5 seconds to indicate the correct supply of power to the
equipment. Upon receiving a code, the receiver checks whether it is in its memory, activating the
corresponding relay. The relay activation mode is selected in either impulse (monostable) or
ON/OFF using the Imp/Bies jumper (only with the relay 2).
For adjustment of relay 1, see manual of the programming tool.
PROGRAMMING
Manual programming
Press the receiver programming button for 1 sec. and an acoustic signal will be heard. The
receiver will enter programming (see table). If the receiver programming button is held pressed
down, the receiver will pass cyclically from one configuration to the next. Once the programming
configuration for the transmitter to be registered has been chosen, send the code to be
programmed by pressing the transmitter. Every time a transmitter is programmed, the receiver
will issue an acoustic signal for 0.5 sec.
EN
9
BASIC-2B
868,35MHz
High security rolling code
500 codes
2 relays
12/24Vac/dc ±10%
1A
60mA / 90mA
-20ºC to +85ºC
IP54 (with glands IP65)
63x74x25mm
82x190x40mm
3200683