Horizon Global 76473 Instrucciones De Instalación página 6

5. Install hitch - Using pull wire, feed the carriage bolts and spacers into frame rails and bracket holes from forward most frame rail hole. Raise hitch into position and
align holes with holes in frame rail. Remove pull wires and loosely install M8 bolts, conical washers, flat washer and hex nuts to hitch, see Figure 1.
6. Tighten all 1/2-13 Gr5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M). Tighten all M8 fasteners with torque wrench to 20 Lb.-Ft. (27 N*M)
o
n o
Frame Rail
m
p
②
②
l
q
l
q
7. Reinstall exhaust and sensor – Raise exhaust back into position and secure sensor in place using original hardware removed in step 1.
©2021 Horizon Global™ Corp - Printed in Mexico
Drilled Holes
Figure 1
Exhaust
Hanger
Brackets
Access Hole
Sheet 6 of 18 76473NP 6-2-21 Rev. A