CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appli-
ance is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (I) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 8 to 10 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
ommended that the first charge of the battery
be of 10 hours in duration).
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has
been removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
USE:
- The appliance can be used directly connected
to the mains, or by using his batteries.
- Unroll the cable completely before plugging it
in.
- Take the length of cable required out of the
housing.
- Connect the appliance to the mains.
- Use the height selector (A) to reach the desired
shaving level.
- Turn the appliance on, by using the on/off
switch.
- Turn the appliance on, by using the on/off
button.
- Turn the appliance on, by using one of the
speed selection buttons.
- The pilot light (J) comes on.
HOW TO SHAVE CLOTHES:
- Place the garment on a smooth surface.
- The remover's handle moves and adapts to the
contours of the fabric. This feature also makes
it suitable for removing lint from furniture and
carpets.
- Do not use the appliance on garments that are
being worn in order to avoid damage on the
user or garment.
- For best results, please follow these recom-
mendations:
- For fast remove, take the remover circle and
shave in small range removing to and forth on
clothes. (Fig. 2).
- For sticking lint, move on the clothes perpen-
dicularly and parallel until is removed. (Fig. 3).
- On thin texture clothes, pile them up into two
layers and shave them gently. (Fig. 4).
- On clothes with protrudes or applications,
avoid contact with the applications or pro-
trudes. (Fig. 5).
- On clothes with patterns, move the appliance
in the direction of the pattern for better results.
(Fig. 6).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
- Remove the fluff container and empty it accord-
ingly. (Fig. 7).
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Disassemble the appliance in accordance with
the following steps:
- Take off the remover circle. (Fig. 8).
- Remove the outer foil as arrow direction. (Fig.
9).
- Take out the rotative blades and clean the
blades shaft with the brush. (Fig. 10).
- Everselly install the blades and outer foil into
the appliance. (Fig. 11).
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.