Operation - KNOVA KN DP-2000 Manual Del Usuario

ASSEMBLY AND ADJUSTMENTS
WARNING:
To avoid injury from an accidental start, ALWAYS
make sure the switch is in the OFF position, the
switch key is removed, and the plug is not connected
to the power source outlet before making belt adjust-
ment.
BELT TENSION (FIG. P)
Make sure pulleys are aligned properly as shown in Fig. K.
1. To unlock the belt tension, turn the belt tension lock knobs
(1) on each side of the drill press head counter clockwise.
2. Move the motor (2) toward the front of the drill press to
loosen the belt tension.
3. Position the belt on the correct pulley steps for the desired speed.
4. Pull the motor away from the drill press head until the belt
is properly tensioned.
NOTE: Belt tension is correct if the belt deflects approximate-
ly 1/2 inch when pressed at its centre.

OPERATION

BASIC DRILL PRESS OPERATIONS
SPEEDS AND BELT PLACEMENT (FIG. Q)
This drill press has 5 speeds, as listed below:
800 RPM 1260 RPM
2400 RPM 3450 RPM
See inside of the pulley guard for specific placement of the
belts on the pulleys to change speeds.
WARNING:
To avoid possible injury, keep guard closed, in place,
and in proper working order while tool is in opera-
tion.
Belt / pulley position-RPM chart
BELT. A-1
Fig. Q
BELT. D-4
ON/OFF SWITCH PANEL (FIG. R)
The ON / OFF switch has a removable, yellow plastic key.
With the key removed from the switch, unauthorized and haz-
ardous use by children and others is minimized.
1800 RPM
BELT. C-3
BELT. B-2
BELT. E-5
5. Tighten the belt tension lock knobs (1) on each side of the
drill press head.
1. To turn the drill press ON, insert yellow key (1) into the slot
(2) in the centre of the switch.
2. Push the key firmly into the slot, and then push switch to
the ON position to start the drill press.
3. To turn the drill press OFF, push the switch to the down
position.
4. Remove the yellow switch key, when the saw has come to
a complete stop, by gently pulling it outward.
WARNING:
ALWAYS lock the switch OFF when the drill press
is not in use. Remove the key and keep it in a safe
place. In the event of a power failure, blown fuse, or
tripped circuit breaker, turn the switch OFF and re-
move the key, preventing an accidental start-up when
power comes on.
10
Fig. P
Fig. R