Tabla De Contenido; Product Specifications; Proposition 65 Warning - KNOVA KN DP-2000 Manual Del Usuario

TABLE OF CONTENTS
Product specifications ......................................................... 1
Proposition 65 warning ........................................................ 1
.
Power tool safety ................................................................. 1
Drill press safety .................................................................. 2
Electrical requirements and safety ....................................... 3
Carton contents ................................................................... 4
Know your drill press ........................................................... 5

PRODUCT SPECIFICATIONS

Motor: 1/4 H.P. 120 V. 60 Hz.
Spindle taper: JT 33
Capacity: 1/2" (0 - 13 mm)
Speeds: (5) 800 - 3,450 R.P.M.
Chuck: 1/2" (13 mm)
Swing: 8" (203.2 mm)

PROPOSITION 65 WARNING

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
(known to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment, such as dust masks that are
specially designed to filter out microscopic particles.
POWER TOOL SAFETY:
Before using your drill press, it is critical that you read and understand these safety rules. Failure to follow these rules could
result in serious injury or damage to the drill press.
Good safety practices are a combination of common sense, staying alert and understanding how to use your power
tool. To avoid mistakes that could cause serious injury, do not plug in your power tool until you have read and under-
stood the following safety rules:
1. READ and become familiar with the entire instruction man-
ual. LEARN the tool's application, limitations and possible
hazards.
2. KEEP GUARDS IN PLACE and in work order.
3. DON'T USE IN DANGEROUS ENVIRONMENT. Don't use
power tools in damp or wet locations, or expose them to rain.
Keep work area well lighted.
4. DO NOT use power tools in the presence of flammable
liquids or gases.
5. KEEP WORK AREA CLEAN. Cluttered areas and benches
invite accidents.
Glossary and adjustments ................................................. 6
Assembly and adjustments ................................................ 6
Operation ........................................................................... 10
Maintenance ...................................................................... 13
Troubleshooting guide ....................................................... 14
Parts list ............................................................................. 15
Spindle travel: 2" (50.8 mm)
Overall height: 22-5/8" (574.6 mm)
Column diameter: 1-13/16" (46 mm)
Table size: 6-5/16" x 7-1/4" (160 x 158 mm)
Base size: 12-3/16" x 7-3/4" (310 x 196 mm)
6. KEEP CHILDREN AWAY. All visitors should be kept a safe
distance from work area.
7. DON'T FORCE THE TOOL. It will do the job better and
safer at the rate for which it was designed.
8. USE THE RIGHT TOOL. Do not force tool or attachment to
do a job for which it was not designed.
9. WEAR PROPER APPAREL. Do not wear loose clothing,
gloves, neckties, rings, bracelets, or other jewellery, that may
get caught in moving parts. Non-slip footwear is recommend-
ed. Wear protective hair covering to contain long hair.
1