Kohler K-1278 Guia De Instalacion página 4

Faldones acrílicos
Ocultar thumbs Ver también para K-1278:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Square
Apron Frame
4. Install the Apron (cont.)
Square the apron frame to the rim of the bath/whirlpool.
Secure the sides of the apron frame to the studs with the screws provided. Shim as necessary to fill
any gaps.
Secure the bottom of the apron frame to the subfloor with screws or floor anchors. Shim as
necessary to fill any gaps. Approximately 1/2" (1.3cm) of shimming will be necessary if installing
this apron to the K-1266/K-1267 bath/whirlpool.
Thread the carriage bolt out until it makes contact with the bath/whirlpool. Then secure by
threading the nut up against the backside of the brace.
Center the apron panel on the apron frame. Press the panel onto the frame so that each of the
fasteners engage.
5. Removing the Apron
To service the bath/whirlpool, gently pry out the bottom of the apron panel using a flatblade
screwdriver.
1018323-2-B
Carriage Bolt
Bath
Fastener
Shim (if necessary)
Subfloor
Apron
Screw
Panel
Stud
4
Apron Panel
Screwdriver
Apron
Frame
Kohler Co.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-1279K-1283

Tabla de contenido