Forno FFSGS6275-30 Guia De Instalacion página 21

oven
Rear cover bar
Tighten screws
Back cover plate
Tighten screws
A. Open the rear cover bar by removing the screws.
B. Use the open wrench to remove the screws from pipe connector.
C. Take out the 1.18 LPG injector from the part bag and replace the 2.0 NG injector by the 1.18 LPG injector.
D. Loosen the screws and adjust the diameter of the air inlet hole to 0.32"
E. Fix the pipe connector and the gas inlet by the screws.
F. Fix the rear cover bar by the screws
G. Install the back cover plate by the screws
Back cover plate
Injector diameter for oven burners:
NG ---2.0 LPG --- 1.18
IMPORTANT: Keep the injectors removed from the range for future use.
STEP 5: Reconnect Gas and Electrical Supply
19