Cleaning - Zummo ZG14 Manual Del Usuario

2 If the faucet tray is not assembled or is not in place, the machine will not operate
and the display will show an Error message by displaying a flashing dark tray.
3 If for any reason the machine gets blocked during operation, after a few seconds
the motor will stop automatically and the display will show an Error message with a
faulty flashing icon, until the cause of the blockage is removed.
4 Thanks to a thermal protection system in the motor, in the event of overheating the
machine will stop and the display will show an Error message and a thermometer
icon. In this case, please wait approximately 10 minutes to allow the motor
temperature to decrease. The error message will disappear. Please check that the
ventilation gratings are not obstructed.
5 If there is no message on the display, it means there is no power supply. Check that
the power switch is on and that the plug fuse is not burnt out (Fig.16).
8
MACHINE CLEANING
The machine squeezing area and parts must be cleaned daily.
ƒ
We recommend that the machine is in an upright position, before performing any cleaning.
Please never turn the switch off, while the machine is working. Once the juicer is in an
upright position, all parts can be easily removed and clean. Failure to follow this
recommendation will cause the machine to stop in a position that impedes cleaning;
possibly leading to breakage of parts due to poor handling.
ƒ
Disconnect the machine turning the power switch off. (Fig. 3). Then the digital display will
turn off. (Fig. 4).
ƒ
Remove the Front Cover and wash it using a damp cloth. ATTENTION!: NEVER use
products that may scratch it).
ƒ
Faucet tray, Juice tray and Blade are removed by unscrewing the fastening nuts and pulling
outwards horizontally.
ƒ
Unscrew the Balls inside the Juice tray (Fig. 5). There is one washer underneath each Ball.
Be careful not to lose them! You may use a dishwasher to wash Juice tray, Filter and
Blade (except the faucet tray). TAKE EXTRA CARE WITH THE BLADE (Fig. 12) since it is
very sharp and may cause injuries.
ƒ
Wash the faucet tray using a damp cloth. (¡ATTENTION!: NEVER use products that may
scratch it). Do not wash the FAUCET TRAY using hot water or dishwasher at temperature
over 40ºC. In case of distortion of the Faucet Tray, this will not be covered by the
guarantee.
ƒ
Remove the Cups unscrewing the Fastening Nuts, and wash them.
ƒ
Remove and wash the Plastic Bins and the Bins Base.
ƒ
Once all plastic parts have been removed, clean the machine stainless steel front.
16