BGS technic 70057 Manual De Instrucciones página 12

TROUBLESHOOTING
FAULTS
Material does
not flow freely
Sandblasting
Finish is not
as expected
When there are other faults, please contact to a sandblasting professional or your local store.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
POSSIBLE CAUSE
Air is not dry enough.
Air pressure too low
Attachment not
properly seated
Clogged sandblasting
material supply line(s)
Air is not dry enough
Size of the sandblasting
material is not uniform
Sandblasting material
is contaminated
The attachment is worn
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
SOLUTION
Fit a water separator (water trap)
to your compressed air system.
Increase the output pressure
on your compressor.
Ensure that the attachment is
fitted firmly to the device and that
no air can escape at the sides.
Check that clumps of sandblasting material
are not clogging the supply lines.
An air blow gun is the best tool for cleaning
any clogged supply lines.
(Wear protective goggles!)
Check the outlet on the tank.
Fit a water separator (water trap)
to your compressed air system.
Replace the sandblasting material.
Sandblasting material should
be cleaned/replaced.
Replace the attachment
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed