Disinfections; Recycle Batteries; Authorized Repair Service; Section 7: Technical Specifications - AngelSounds JPD-100S mini Manual De Instrucciones

* Don't remain any cleaning solution on the surface of the device.
Wipe the surface of sensor of transducer with 70% ethanol or alcohol,
self-air dry or clean with a clean, dry cloth.

6.4 Disinfections

Cleaning the unit surface and the transducer as the above mentioned,
then wipe the surface of transducer with 70% ethanol or alcohol, clean
the transducer surface with a dry, soft cloth.
* Don't use low temperature steam sterilization or other way to sterilize
* Don't use high temperature sterilizing process

6.5 Recycle Batteries

The battery is recyclable. Remove the old battery from the Product and
follow your local recycling guidelines or Refer to local regulations.
WARNING: Irregular treatment of batteries may be result in
hazards to health and environment.

6.6 Authorized Repair Service

The Product has no user-serviceable internal components. Try to
resolve any maintenance issues with the Product by using the
Troubleshooting Table presented in this chapter. If you are unable to
resolve the problem, contact Jumper Medical Equipment Co., Limited
Service.
NOTE: The warranty will be void upon unauthorized disassembly or
service of the product.

Section 7: Technical specifications

This section presents the specifications and safety standards of the
product.
NOTE: The following specifications are subject to change and are only
noted as a point of reference.
Product name: Fetal Doppler
Mode: JPD-100S(mini)
15