Base Extension - MyBinding Fletcher-Terry 48 2200 Manual De Instrucciones

7. The scale in the Right Squaring Arm has pressure sensitive adhesive on the underside. Slide the scale out to the
right several inches. Peel off 4" of the protective paper from the adhesive and
slide the scale back to the left, but do not set the adhesive yet. See Figure 14.
8. Draw a vertical line 3" from the left edge of a mat. Place the mat's lower edge
against the Right Squaring Arm and slide it slowly to the left until it contacts
the vertical blade (sizing blade) which should be rotated downward. The scale
should now be positioned in its slide aligning the pencil mark with the 3" index
on the scale. Press down on the right end of the scale so it adheres to the Right Squaring Arm. If it should ever be
necessary to reposition this scale, it should will be easy to pry up the adhered section and relocate the scale.
1. Remove the Mat Guide (A), Mat Guide Slide (B) and the Bracket (C) on the left side of the Base. Set the fasteners
aside to be used again.
2. Remove both End Caps (D) from the machine and save. Set the screws
aside to be used again.
3. Three sets of screws and square nuts are provided. Only two sets will be
required for 40" and 48" models. Insert button head screws through the
holes on the left edge of the Base with the threads sticking out. Screw
the square nuts on the screws only one or two turns. They must be very loose for now.
4. Slide the optional Base Extension on the nuts. You will note the square nuts fit in a groove on the the right side
of the Base Extension. Align both ends of the base members and tighten the screws and square nuts. You will use
the hex wrench supplied with the machine.
5. Assemble the new End Caps using the screws from the discarded ones and additional screws from the parts bag.
Attach the three rubber buttons from the parts bag to the bottom ribs of the Base Extension.
6. Install the new, longer Mat Guide Slide on the Base, using the fasteners from the old one. Slide the Mat Guide on
the Mat Guide Slide and reinstall the Bracket on the left edge of the Base Extension. Square the machine as
shown in the adjustments section of this Owner's Manual.
7. A new, longer Upper Measuring Stop Slide is provided in case you are using the Measuring Stop option. Simply
exchange it on the Upper Measuring Stop. Also, longer inch and metric scales are provided in this kit to replace
those on top of the Mat Clamp to permit you to set the Lower Measuring Stop to larger mat border dimensions.
If you wish to install these new scales, mark the Mat Clamp at the zero position before removing the old scale. In this
way you can easily locate the new scale.
8. The new Base Extension has a tapped hole in line with the Mat Guide Locking Strap. You may wish to mount the
Upper Locking Knob on top of the Base Extension. This will accommodate the same mat border dimensions as
the standard machine. When larger mat borders are required, the Upper Locking Knob can be moved to the
Bracket on the left side of the Base Extension.

BASE EXTENSION

10
Figure 14
B
A
D
Figure 15
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
C