Tabla de contenido
Publicidad
TROUBLESHOOTING GUIDE
PROBLEM
Frayed bevel cuts
Not cutting
through the mat
Excessive overcut
Undercut
Head binds
Head too loose
"Hook" in cuts
Head "rumbles"
FOR ASSISTANCE, CONTACT THE FLETCHER-TERRY COMPANY CUSTOMER SERVICE DEPARTMENT AT
800.843.3826 (U.S./CANADA) OR customerservice@fletcher-terry.com.
POSSIBLE CAUSE
Dull blade
Worn out slip sheet
Blade projection
Worn or broken blade
Pressing too hard on
the handle
Blade projection
Measuring Stop
Blade projection
Measuring Stop
Head Bearings
Head Bearings
Blade projects too far
Head loose
Roller Bearing path dirty
Roller Bearings dirty
CORRECTION
Change to a new blade
Use fresh slip sheet
Extend projection
of blade
Replace blade
Ease up on pressure
Adjust projection
of blade
Adjust Measuring Stop
Adjust projection
of blade
Adjust Measuring Stop
Adjust Head Bearings
Adjust Head Bearings
Adjust projection
of blade
Adjust Head Bearings
Clean Mat Clamp
Remove Head and
clean Bearings
Use tape to remove
foreign material
14
REFERENCE
SET UP
HOW TO CUT MATS
SET UP
SET UP
HOW TO CUT MATS
SET UP
HOW TO CUT MATS
SET UP
HOW TO CUT MATS
MAINTENANCE
MAINTENANCE
SET UP
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
Publicidad
Tabla de contenido
