Simer 2700 Manual Del Usuario página 4

Sistema de bomba de sobrepresión de paletas periféricas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation / Electrical
DISCHARGE PIPE CONNECTION
(FIGURE 3)
Connect the 5-way tank tee to your plumbing system.
Snifter Valve
Flow
1" PipeTo
Household
Water System
Pressure
Switch
Priming
Port
Discharge
Port
Flow
Priming
Check Valve
Tee
(Purchase
Separately)
1" Pipe From
Water Source
Water Level
Foot Valve
Figure 3 – Suction and discharge connections for Model
2700E. For Model 2700, connect suction piping as
shown. Connect discharge port of pump directly to
household plumbing system.
Use only teflon tape for making all threaded connections to the pump itself. Do not use pipe joint compounds
on plastic: they can react with the plastic. Make sure that all pipe joints in the suction pipe are air tight as well
as water tight. If the suction pipe can suck air, the pump will not be able to pull water from the water source.
WIRING CHART – RECOMMENDED WIRE AND FUSE SIZES
Maximum
Model
Volts
2700, 2700E
115
* When using fuses, dual element or Fusetron time delay fuses are recommended for all motor circuits.
For parts or assistance, call Simer Customer Service at
Tank
Adapter
5-Way Tank Tee
Pressure
Gauge
Pump Intake
Port
4555 0304
Sealing Pipe Joints
Branch
Load
Circuit Breaker
Amps
Rating (Amps)*
6.0
15
ELECTRICAL
Hazardous voltage. Risk of dangerous or
fatal electric shock. Plug the pump into a 115 Volt, 60
Cycle, Ground Fault Circuit Interrupter (GFCI) protect-
ed grounded outlet only. The pump is equipped with a
3-wire, grounded, cord and plug. Do not modify or
remove the plug. Make sure the pump circuit meets all
codes and ordinances that apply. To avoid dangerous
electrical shock hazard, keep the cord dry at all times.
Lubrication
The motor is lubricated at the factory for the life of
the bearings. The pump seal is water cooled and self
lubricating.
Pump Service
Hazardous voltage. Can shock, burn, or
cause death. Unplug the pump before servicing it. Do not
handle the pump or attempt to work on the pump with
wet hands or while standing on a wet or damp floor.
The motor has an auto-reset thermal overload protector.
If the motor overheats, the overload will cut off the
power to prevent damage and will reset after the motor
cools. If the overload trips repeatedly, check the pump
for the cause (low voltage, a clogged impeller, etc.).
Distance in Feet (m) from Motor To Supply
Wires Sizes AWG (mm
0-100 (0-30)
101-200 (31-61) 201-300 (62-91) 301-400 (92-122)
14 (2)
14 (2)
1-262-728-5551
4
)
2
12 (3)
10 (5.5)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2700e

Tabla de contenido