Palram FERIA 3x3.05 Manual De Instrucciones página 10

Notes During Assembly
Use a soft platform below the parts to avoid scratches and damages.
Product dimensions can be adjusted to your specific needs:
1.The wall -mounting profile (top -back) can be adjusted from 260 to 305 cm (102.4" to 120") above ground.
The adjusting is done when measuring and drilling (Step 7).
Please note the installation recommendations' height suggested in Diagram A.
It is possible to fix the Patio Cover back wall height at the lowest point of 260 cm/102.4". This method is optional if
the assembly conditions and exterior walls do not allow to follow the suggested installation as appears in the manual.
Please note that the product appearance may slightly change as a result, however snow load weight does not change.
2. Poles distance from the wall can be adjusted from 226 to 286 cm (89" to 112.5") as suggested in Diagram B1.
Poles distance from the side edges can be adjusted from 0 to 54 cm (0" to 21.3") as suggested in Diagram B2.
The adjusting is done after assembly and before anchoring (Step 21) by sliding poles and profile 1041 at the roof
profiles' channels.
3. Wall mounting and distance from the wall determine the roof angle and the total depth of the product (distance of
gutter from the wall). Higher wall mounting and shorter distance between wall and poles increase the roof angle and
shorten the total depth as suggested in Diagram C.
Steps
Step 6: Apply silicone sealants on the inner part of 8116 & 8117 and connect to the profile.
Step 10: Please apply silicone sealants above beam 7288, in order to prevent water from seeping in.
Step 13: Make sure that the angle between the back wall profile and the panel supporting profiles is 90 degrees.
Assembly of the panels should start from the middle of the patio cover to each side alternately.
Step 21: Please adjust the poles (inside out and sideways) by sliding them to their final position prior to anchoring.
Make sure that the poles distance from the Patio cover side edge does not exceed 54 cm/21.3".
*Please note: Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid (Step 22).
*Tighten all screws when completing assembly.
Note:
The wall anchoring kit supplied with this product is suitable for concrete or solid brick walls only.
Other wall types need an accordant wall fixation kit.
260-305cm
102.4"-120"
226-286cm
89"- 112.5"
.
.
.
- 13°
.
+ 17°
..
w
+
-