port of your ADSL broadband Router.
③
Plug the Powerline Adapter into a wall socket next to the computer.
④
Turn on your computer.
⑤
Check and confirm that the Power LED , Ethernet LED , and Powerline LED
on the Powerline Adapter are ON.
The hardware connection mechanism is shown below:
Note
Where the MAINS plug or an appliance coupler is used as the disconnected
device, the disconnect device shall remain readily operable. The idle wall
sockets or electrical outlets in your household electrical circuit can be used
normally without interference from the network.
Chapter 3 Advanced Feature: How to Use the Pair Buttons
3.1 Pair (Secure with 128 bits-AES)
The Homeplug AV standard uses 128-bit AES (Advanced Encryption Standard) to
safely transmit data between Powerline adapters. For the powerline adapters to
communicate with each other they all need to use the same Network Membership
EN-10