Technical Data - Urrea TRM300 Manual De Usuario

If repair is made by a person with no knowl-
edge and skill for repairs, optimun perfor-
mance cannot be obtained, and also accidents
and injuries can occur.
NOT OPERATING WHEN TURNING THE
SWITCH "ON".
• The motor is not running.
1be power supply plug is disconnected. Insert
the power supply plug into the plug socket.
The carbon is worn. Replace to a new one ac-
cording to the procedures in the maintenance
section.
Voltage is low. Check on voltage.
The motor is burned. Repair is necessary.
The switch is damage. Repair is necessary.
• The motor is running.
The gear is broken. Repair is necessary.
• Rotation of the main shaft is defective.
Voltage is low. Check on voltage.
The motor is burned. Repair is necessary.
• Not stopped immediately even
turning OFF the switch.
The carbon is worn. Replace to a new one ac-
cording to the instructions in the maintenance
section.
The lead wire is disconnected. Repair is neces-
sary.
• Oil is not supplied appropiately.
Oil amount is low. Replenish oil.
Chips are clogged. Rcmove chips in the oil tank.
The die head is not fitted correctly. Fit the die
head to correct position.
• Oil drops from the pipe back.
The back scroll side is set lowly. Set the back
scroll side to be high.
• The die head can not be fit.
Chips are attached. The die head touches the
pipe piece, etc. on the tank top cover.
Remove chips attaching to the die head fitting
shaft and hole. Remove the pipe piece, etc.
• The movable part does not move
smoothly.
Chips are clogged. Remove chips.
• The chaser is not engaged to the pipe.
The cbaser is wom. Replace to a new one.
The chaser is chipped. Replace to a new one.
The chaser is fit to incorrect position. Fit the
chaser according to the die head instructions.
THREADING CAN NOT BE MADE CORRECTLY.
• Thick, Thin.
The die head is not adjusted correctly. Adjust
the die head according to the instructions in
the operation section.
• Long, Short.
The die head is not adjusted correctly. Adjust
the die head according to the instructions in
the operation section.
The chaser is worn. Replace to a new one.
The chaser is chipped. Replace to a new one.
Tluead cutting oil is deteriorated. Replace to
new thread cutting oil.
The chaser is fit to incorrect position. Fit the
chaser according to the die head number.

TECHNICAL DATA

when
VOLTAGE-FREQUENCY
SPINDLE SPEED
THREADING CAPACITY
CURRENT
POWER
WEIGHT
E N G L I S H •
120 V ~ 60 Hz
40 r/min
1/2"-2" (12,7 mm -50,8 mm)
17 A
600 W
49 kg (108 lb)
U se r 's m a nu a l
19