Technical Specifications - Master FLUTE Manual De Uso Y Mantenimiento

Ocultar thumbs

página de 5

/ 5
Marcadores

Idiomas disponibles

FLUTE - FLUTE 5

Dear Customer, thank you for purchasing a MASTER

S.p.A. product. This guide contains all the information

you will need concerning the use of this product.

Read the instructions carefully and keep them for further

consultation. The FLUTE - FLUTE5 transmitter is

designed specifically to control sun awnings, blinds,

roller shutters, screens or similar items. All other use

beyond the field defined by MASTER is forbidden.

This, as well as the breach of the instructions given in this

guide, shall release MASTER from any liability and shall

annul the product warranty. Water, humidity, heat

sources and accidental knocks may damage the device.

Do not use abrasive products or solvents to clean the

product.

Notes on radio systems

Do not use radio systems in places with strong

interference (for example, near police stations,

airports, banks, hospitals). It is in any case advisable to

carry out a technical inspection prior to installing any

radio system in order to identify possible sources of

interference. Radio systems can be used where any

disturbances or malfunction of the transmitter or

receiver do not constitute a risk factor, or if such factor

is eliminated using appropriate safety systems. The

presence of radio devices working at the same

transmission frequency (433.42 MHz) may interfere

with the radio receiver and reduce the range of the

system, limiting functionality.

Disposal

At the end of the product life cycle,

dispose of the device in compliance

with local regulations. This product

could contain substances that are

harmful to human health and the

environment: do not dispose of the

product in domestic waste.

All products and technical specifications given in this document are subject to variation without notice. The manufacturer shall not be liable for damage resulting from improper, incorrect or

unreasonable use.

Contents of package

1 transmitter

2 AAA alkaline batteries

1 support

2 plugs

1 instruction sheet

1 tool

Battery insertion/replacement

The transmitter is powered by two alkaline AAA batteries. To replace the batteries, unscrew the indicated screws (see the

figure below) and extract the bottom of the transmitter; replace the old batteries with new ones of the same type, respecting

polarity. Pushing the bottom into its place and lock it with the screws. Using other types of batteries could lead to a risk of

explosion. Used batteries must be disposed of in special containers. As the batteries become used, the range of the

transmitter drops gradually until it is completely unusable. Replace the batteries at least once every 2 years.

Unscrew the indicated screws to

extract the bottom

FUNCTIONS ASSOCIATED WITH THE TRANSMITTER BUTTONS

Tilting

Press STOP* twice and hold down UP or DOWN

rev02.1_22.07.17

Favorite position

* The STOP button must be pressed in quick succession

Sun/Automatic lowering function

FLUTE5 only: select the channel (sequencer excluded)

NOTE: Some receivers may not associate some operations to some transmitter buttons

or associate different operations to those described to the transmitter buttons. In this

case, please refer to the receiver instruction manual.

Flute 5: Sequencer function

FLUTE 5 is equipped with a Sequencer function. The virtual channel (all blue LEDs on) sends the selected command to all

radio channels. To select it, press several times the Channel Selection button until you have all the Channels LEDs lit .

WARNING: respect the polarity of the

batteries during insertion!

Looking frontally at the remote control, the

right battery must be inserted with the +

upwards, the left one with the + downwards.

To memorize

Press STOP* 6 times

then keep DOWN

pressed until the signal

of the motor

(approx. 5 seconds)

Holding down STOP,

press UP until the RED

LED state changes

(approx. 2 seconds)