Pump Pressure; Wiring Diagram - Pinnacle Products International Protemp PT-45-KFA Manual Del Usuario E Instrucciones De Operación

PUMP PRESSURE:

While heater is operating, turn adjusting screw
clockwise to increase, counter-clockwise to decrease
pressure. Correct pump pressure is as follows:
Model Number
PT-45-KFA
PT-70T-KFA
PT-75T-KFA
PT-125T-KFA
PT-175T-KFA
PT-215T-KFA
Tolerance ± 10%
Pressure Valve
Adjusting Screw
Figure 18
70T / 75T / 135T / 190T / 215T-KFA With Optional Power Outlet
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
®
Maintenance
Pump Pressure
3.0 PSI
4.0PSI
4.2PSI
5.0 PSI
7.5 PSI
9.0 PSI
Wiring Diagrams
45-KFA Without Optional Power Outlet
NOZZLES:
Nozzles should be cleaned or replaced at least once
per heating season. Contaminated fuel could make
this necessary immediately. To clean dirt from nozzle,
blow compressed air through nozzle front. It may be
necessary to soak the nozzle in 1-K kerosene to loosen
any dirt particles.
Nozzle Face
70T / 75T / 135T / 190T / 215T-KFA Without Optional Power Outlet
Kerosene Forced Air Heater User's Manual
11
Nozzle
Burner Head
Figure 19