Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly continued
STEP 6
Follow the instructions in step 5 to temporarily attach a second beam
on the opposite side of the posts (fig. 4).
Outer Most
Notches
•
Top View
Check for level between both beams and correct if necessary. Drill 2
holes through each post/beam connection using a ½ in. drill bit (be sure
they are centered horizontally on the post) (fig. 5). Insert a carriage bolt
into each hole and secure it with the shoulder (fig. 5).
•
• •
Carriage Bolts
BeamFig4.ai
STEP 7
Attach the remaining two beams to the remaining posts following steps
5 and 6.
STEP 8
Slide the joists on top of the beams, notch side down. The notches in
the joists will slide into the notches in the beams (fig. 6). Toenail the joist
to the beam at each connection, one nail on each side.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT
PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
©2016 Universal Forest Products, Inc. Outdoor Essentials is a registered trademark of Universal Forest Products, Inc. All rights reserved.
WOODLANDS 12x12 PERGOLA KIT INSTALLATION INSTRUCTIONS
•
•
Side View
2801 East Beltline NE, Grand Rapids, MI 49525 616.364.6161 8940_7/16
www.outdooressentialproducts.com
STEP 9
Carefully trim the top of any posts that extend above the joists to
create a level surface for the rafters. Place the 2x4 rafters on the top
of the joists at your desired spacing (fig. 6). For equal spacing, leave
a 2.6 in. gap between each rafter. Secure each rafter to the joists with
wood screws (1 per joist/rafter connection).
Post
Beam
fig. 4
•
•
•
STEP 10
To stabilize the pergola, add 4x6 braces between each post and beam or
joist. Measure the two inside faces of each post 61-5/8 in. from the ground
and mark. Place the bottom of the brace against the mark and the top of
the brace against the inside of the outermost joist or beam. Attach the
brace to the post by driving three wood screws through the brace into the
post. Attach the brace to the joist or beam in the same fashion. Repeat
until all 8 braces are in place (fig. 7).
fig. 5
•
61-5/8"
•
•
BraceFig7.ai
•
Beam
JoistFig6.ai
•
•
Joist
•
•
Beam
Brace
Post
fig. 7
•
2x4 Rafter
•
Joist
fig. 6
Publicidad
