Temper Koban KDP5 Manual Del Usuario página 15

Button
Unlock KDP5 RC buttons
• By pressing this button, KDP5 RC buttons will be unlocked.
Thereafter, the remote controller can be used to set presence
detector.
• The default channel is CH1 (Load I) after unlocking KDP5 RC.
• When operating KDP5 RC to detector under unlock mode,
detector will lock automatically 5min after the last operating
if button is not pressed.
Test mode
By pressing
by flashing of detector's LED for 2sec.
Walking through the detection coverage, both load I (CH1)
and detector's LED turn on 2sec once detector is triggered
(Reaction is regardless of Lux value).
LoadⅡ(CH2) has no reaction in test mode.
The previous setting values can be stored and duplicated to
other detector
1. Set the desired Lux and time values on one detector by using
the remote controller.
2. Then by pressing MEMO button for approx. 3sec aiming to
above detector, the Lux and time settings of this detector
will be saved into this remote controller by detector's LED
flashing.
3. By pressing MEMO button again for approx. 1sec aiming to a
new detector, the saved settings can be duplicated to the one.
4. Transfer the settings to detectors desired by repeating above
last step. If no data is saved in the remote controller, detector
has no reaction after press MEMO button.
5. Battery removed for more than 5sec or MEMO button is
pressed, all the data in IR remote controller will be deleted.
To reset settings on presence detector
By pressing RESET button aiming to the detector, all settings on
presence detector will go back to potentiometers' settings, and
all MEMO data will be deleted.
www.grupotemper.com
KDP5 remote control
Function
button to enter into Test mode, it is confirmed
Remote control
Instructions manual | 15