Temper Koban KDP5 Manual Del Usuario página 16

KDP5 remote control
Remote control
Button
To adjust Lux value
By pressing corresponding button, the selected light level
threshold is set to presence detector for switching on the
connected load. Load II (CH2) is independent of Lux value.
To read-in the actual ambient light level
Actual ambient light level can be read-in as threshold for
switching the connected load, if the provided Lux values do not
match user
The steps are as below: Press
flashing to enter into learning mode, learning time is 10sec.
Then the actual ambient light level is read-in confirmed by both
load and LED turn on for 5sec to indicate KDP5 RC learning
successfully and then turn off.
Afterwards, it returns to Auto mode.
Note: If the ambient light level is out of the range of 10
- 2000Lux, detector will learn for 10sec, then LED flashes
quickly for 5sec to indicate KDP5 RC learning is failed, and the
alternative of 10Lux or 2000Lux value will be stored depending
on under 10Lux or above 2000Lux value.
Select load for time setting
By pressing
and to set the delay off time value of loadⅡ(CH2).
invalid if the detector has only one load.
Time setting for Time / Time1 or Time2
By pressing
off time value. Either
then press the corresponding time value button to set it, which
is confirmed by detector's LED flashing for 2sec.
Short impulse mode for load I (CH1)
By pressing
confirmed by flashing of detector's LED for 2sec. Load I (CH1)
will be on 1sec and off 9sec when detector detects movement.
Detector acts depending on movement and the pre-set Lux
value under short impulse mode.
Instructions manual | 16
Function
s requirement.
'
to set the delay off time value of load I (CH1),
to select the load desired to set the delay
or is pressed, LED flashes 2sec, and
button to enter into short impulse mode, it is
button till detector s red LED
'
www.grupotemper.com
is