Adjusting The Spray Gun - Mato LubeJet-eco Instrucciones De Empleo

Operating Instructions
Description:
The LubeJet-eco compressed air spraying unit allows the spraying of grease directly from the Lube-
Shuttle System cartridge. It is suitable for coating large surfaces on machines, vehicles, gears, wire
ropes, chains and telescopic rods uniformly with lubricant. Commercial lubricants and greases can be
sprayed from the Lube Shuttle System cartridge. Operating the trigger on the spray gun starts the
spraying process. The material flow, the air volume and the spray jet distribution can be set on the
gun.
Any other use, or modifications or changes to the LubeJet-eco are only allowed after
discussion with the manufacturer.
Lubricants:
Commercial lubricants and greases can be sprayed.
Pastes with no lubricating properties (with abrasive components)
and silicon pastes must not be used.
Putting into service and Operation:
- Remove the lid of the Lube Shuttle System
cartridge.
- Unscrew the tube body and screw the cartridge
cartridge into the unit.
- Screw on the tube body firmly.
- The gun is now ready to use.
- Connect the compressed air. Pmax. 5 bar
- The spraying process is started by operating the
trigger.
- The material flow, the air volume and the spray jet
distribution can be set on the gun.
Comply with the safety instructions

Adjusting the spray gun:

Spay nozzle
Smooth regulation
of material flow
Smooth regulation
of air flow
Smooth setting of
round jet – wide jet
/ English
Spray gun
Trigger
Air connection
Compressed air
connection hose
Tube body
5