Zamel exta free RDP-01 Manual De Instrucciones página 8

REMOTE CONTROLS PROGRAMMING
COMFORT mode:
Press RNK-04 transmitter's push-button for a longer time.
button of RDP-01 device for a longer time until LED red diode switches on (constant
signal). Next release PROG push-button
red diode switches on (first signal pulsates, next the signal is constant). Press the
same transmitter's pushbutton and release it. LED red diode switches on (the signal
pulsates) and next it switches off - THE TRANSMITTER IS ADDED.
ONE PUSH-BUTTON mode:
Press PROG push-button of RDP-01 device for a longer time until LED red di-
ode switches on (constant signal). Next release PROG push-button.
transmitter's push-button for a longer time. LED red diode switches on (first signal
pulsates, next the signal is constant).
red diode switches on (the signal pulsates), next the LED red diode switches off - it
means the TRANSMITTER IS ADDED.
SWITCH ON/SWITCH OFF mode (two push-buttons):
Press PROG push-button of RDP-01 device for a longer time until LED red di-
ode switches on (constant signal). Next release PROG push-button.
release transmitter's first push-button. LED red diode switches on (first signal pul-
sates, next the signal is constant).
push-button. LED red diode switches on (the signal pulsates) and next it switches
off - THE TRANSMITTER IS ADDED.
TIME mode (one push-button):
Press PROG push-button of RDP-01 device for a longer time till LED red diode
switches on (constant signal). Next release PROG push-button.
release transmitter's push-button.LED red diode switches on (first signal pulsates,
next the signal is constant).
button. LED red diode switches on (signal pulsates) and then switches off - THE
TRANSMITTER IS ADDED.
CAUTION: Every transmitter can cooperate with RDP-01 in a different mode,
depending on how they were added to the device. One transmitter can be
added during one programming cycle. Full memory is signalled with pulsat-
ing LED red diode.
TIME PROGRAMMING
Press PROG push-button of RDP-01 device for a longer time till LED red diode
switches on (constant signal). Next release PROG push-button. Wait (for about 5 sec-
onds) till LED red diode switches on (first signal pulsates, next the signal is constant).
Press PROG push-button of RDP-01 device and then release it. LED red diode
switches off and then switches on (signal pulsates). Every LED diode pulse equals 1
second. After the adjusted time is finished (the number of LED red diode flashes)
press PROG push-button and then release it - TIME IS ADDED.
Maximum time is 18 hours.
Release transmitter's pushbutton. LED
Release transmitter's push-button. LED
Press and release the second transmitter's
Press and release the same transmitter's push-
Press PROG push-
Press the
Press and
Press and then