Lenco MC-460 Manual Del Usuario página 30

Bluetooth
Press the menu button on the Device or on the remote control and select the Bluetooth
mode
Make sure that no other Bluetooth device is connected to the MC-460. ("No Connection
"will show on the display). When a device is connected already, press and hold the 'enter'
button to enter the pairing mode
Activate Bluetooth mode on the device that you want to connect with. Scan for new devices.
(refer to the instruction manual of the device how to scan for new devices). The Lenco will
appear as "Lenco MC-460"on the Bluetooth device list.
Select the "Lenco MC-460"from the list. If you are required to enter a PIN code, enter 0000
(four zeros). Certain devices may also require you to approve the connection.
Once the connection has been successful, "Connected" will appear on the display.
To disconnect a connected Bluetooth device: Press and hold down the [Enter] button for
3 seconds. The message "No Connection" will appear on the display.
Start playback on your Bluetooth device:
Control the playback from the Bluetooth device or from the radio using the Vol+/Vol- on the
device and remote control, Adjust the volume both on the Bluetooth device and the radio.
Press and hold the <" and „>" to skip backward or forward to the desired track .
Press the button on the remote control to skip backward or forward to the desired
track.
Press the "enter" button to pause/play the current track
Vinyl playback:
Please note: the counterweight is fixed and can't be altered.
Put the vinyl record on the platter of the device and select the appropriate rotation speed
(33, 45 or 78 rpm) according to the information on the vinyl record.
Place the arm on the vinyl record.
Note: when the record is finished, the tone arm will automatically return to the rest position.
Don't use force to stop this procedure, since it can damage the mechanics.
Record:
Press and hold the record button for about 3 second to start recording.
The icon appears in the upper right corner.
30