LUND 26510026 Instrucciones De Instalación página 3

Installation Steps
Attach support bracket using M8 Bolt, (2) M8 Flat
6
Repeat Steps 3 thru 7 for passenger side bracket locations.
(Passenger side rear bracket shown)
8
Repeat Step 9 to attach the nerf bar at the middle and
10
NOTE: Actual application may vary slightly from illustrations.
Washers, and M8 Lock Nut.
rear bracket locations.
Attach support bracket to pinch weld using (2) M6
Bolts, (4) M6 Washers, and (2) M6 Lock Nuts.
7
Align the passenger side nerf bar with the passenger
side front mounting bracket and loosely attach using
Bolt Assembly
9
Check boards for final position. Tighten all bracket to vehicle
body hardware to 40 lb-ft. Tighten running board to bracket
hardware to 17 lb-ft. Repeat Steps 1-9 for driver side.
11
Page 3 of 4
Bolt Assembly.
Nerf bar