Microphone Replacement - Biamp Vocia WS­4 Manual De Operación

WS­4/WS­10 & EWS­4/EWS­10 MICROPHONE REPLACEMENT
1. R emove microphone from catch. Remove top and bottom screws
+/40%-?,%0&;'%14(5%4+%-?,%F&::%6-&-;4'%F;-?%-4/^%69/,F(/;8,/%6;G,%)*%L>)*O=%
`=%3.::%1,G,:%-4F&/(6%54.%&'(%1,'(%(4F'%&6%6?4F'%1,:4F=%
3. Detach the white microphone connector from the board (and the Ethernet cable if connected).
4. U se a pointed tool to release the catch located to the right of the microphone on the bottom side of the wall station.
Slide the microphone cord to the left and remove the microphone cord.
5. R emove the metal catch from the original microphone.
Place the metal catch on the new microphone cord as shown below.
6. Slide the microphone cable into the groove until the metal catch snaps in.
12