Compressed Air Supply - Monti Bristle Blaster Manual De Instrucciones

®
Bristle Blaster Pneumatic
6.

COMPRESSED AIR SUPPLY

This compressed air tool is designed for a maximum flow pressure of 90 psi (6.2 bar) at the tool. On the usage of
®
the Bristle Blaster 23 mm Belt, a flow pressure of 90 psi (6.2 bar) at the tool is necessary. On the usage of the
®
Bristle Blaster 11 mm Belt, a flow pressure of 75 psi (5.2 bar) at the tool is necessary.
Correct air pressure will increase the service life!
The supply of compressed air must be free of water. For this reason a water separator must be used to trap con-
densate. If the compressed air hose is too long, the tool cannot be supplied with the necessary air pressure.
For correct operation and the long service life of the compressed air motor, the usage of a lubrication device in the
compressed air line is expressly recommended.
Attention!
Use correct air pressure regulator!
®
Bristle Blaster Belt
23 mm belt
11 mm belt
Attention!
On the usage of the compressed air regulator, a flow pressure of 7.5 - 8.5 bar at the
tool is necessary!
Colour of compressed air regulator
Silver
Blue
Operating instructions
GB/US
17