Descargar Imprimir esta página

Kohler K-1418-GCR Diagrama De Instalación página 2

Bañera con jets de aire

Publicidad

Idiomas disponibles

Idiomas disponibles

No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
42" (106.7 cm)
Product Information
Applicable product:
Drop-in bath with airjets and chromatherapy
Fixture*:
Bathing well:
Basin area, bottom
Basin area, top
Weight
To overflow:
Water depth
Capacity
* Approximate measurements for comparison only.
Drop-in cut-out
70-1/2" (179.1 cm) x 40-1/2" (102.9 cm)
Blower
Heater
motor/
300 W
control:
Recommended accessories:
Adjustable pop-up drain – above or
through-the-floor installation
1035473-1-E
11-3/4"
(29.8 cm)
22"
(55.9 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
K-1418-GCR
48" (121.9 cm) x 27" (68.6 cm)
60" (152.4 cm) x 30" (76.2 cm)
150 lbs (68 kg)
16" (40.6 cm)
94 gal (355.8 L)
V
Hz
220-240 V
50/60
K-7161-AF
36" (91.4 cm)
1-1/16" (2.7 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Blower motor/control:
Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are relocated, the
following two procedures are required: 1. Provide two access
panels. Locate one access panel at the blower motor/control
location and the other access panel at the control box. 2. Relocate
the blower motor and the check valve together. Do not relocate one
without the other.
Floor support under bath must provide for a minimum of 46 lbs
(223 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
A
This bath is designed for drop-in installation only. It is not suited
3
for use in a three-wall alcove with an overhead shower.
Fixture dimensions are nominal and conform to tolerances in ANSI
Standard Z124.1.2.
2
K-1418-GCR
5-1/4" (13.3 cm)
72" (182.9 cm)
3" (7.6 cm)
1-1/2" OD
220-240 V, 15 A, 50/60 Hz
20-1/8"
(51.1 cm)
Kohler Co.

Publicidad

loading